판매가 | 284000 |
---|---|
할인판매가 | 284,000원 ( 284,000원 할인) |
할인금액 | 총 할인금액 원 (모바일할인금액 원) |
적립금 |
0원(0%) 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % 원 % |
제휴적립금 | |
배송방법 | 택배 |
배송비 | 무료 |
상품 추가설명 번역정보 |
배송 | |
---|---|
수량 |
|
상품 정보 | 가격 | 삭제 |
---|
할인가가 적용된 최종 결제예정금액은 주문 시 확인할 수 있습니다.
The FC 3 is a side-address, 3-pattern FET condenser with a transformer-coupled output circuit.
Although previously reported here (based on statements from GAP) to use a 34mm, 3-micron capsule, the sample FC3 microphone we purchased contained a 32mm capsule. This capsule almost certainly has a 6-micron diaphragm. It is a center-terminated K67 type.
Three switches on the mic body enable pattern selection (Cardioid, Omni, Figure-8), a switchable pad (-10dB), and a switchable high-pass filter (cutoff at ~80Hz).
The circuit is a two-stage transistor design, with an emitter follower driving a low-ratio output transformer. This circuit is linear — it does not apply any frequency-dependent corrective filtering to the capsule’s signal, unless the high-pass filter is engaged.
The DC circuit board contains a voltage multiplier that is capable of polarizing the capsule at +60VDC. Individual samples we’ve seen vary from 50–63VDC. Note that in Figure-8, the rear diaphragm is at double this voltage (+120V), while the backplate is at +60.
The FC3 is nearly identical to the CAD GXL3000, although the GXL3000 comes with a higher-quality, larger capsule (35mm O.D., 6 micron diaphragms).
The Golden Age Project FC 3 is also known as: FC 3.
Pickup Patterns | Pads & Filters |
---|---|
Omnidirectional (14.5 mV/Pa; 20 - 20,000 Hz) Cardioid (14.5 mV/Pa; 20 - 20,000 Hz) Bidirectional (14.5 mV/Pa; 20 - 20,000 Hz) |
|
Capsule Dimensions | Impedance | SPL/Noise |
---|---|---|
Diaphragm diameter: 25mm Capsule diameter: 32mm Diaphragm gauge: 6 microns | 250 Ohms (Low) | Max SPL: 140 dB Self-noise: 17.0 dB(A) |
Weight | Length | Max Diameter | Interface(s) |
---|---|---|---|
470g (16.58oz) | 190mm (7.48'') | 50mm (1.97'') |
|
Power Specifications |
---|
|
The GAP FC3 combines a linear circuit with a peaky 32mm K67 capsule type. The result is a not flattering to most sources, creating sibilance on vocals and fatigue on most everything else.
We offer two modification options for this mic.
The stock GAP capsule is a typical 32mm K67 type, found in just about every inexpensive large-diaphragm condenser microphone on the market. It has a peaky and uneven response that is not very musical, and tends to require EQ to fit into a mix.
We recommend replacing it with a K47 type, which will give a more neutral top-end response, with rich midrange detail. Our favorite capsule for this mic (assuming the stock circuit is retained) is the RK-47.
Another option is our RK-12. The voicing of this capsule is bright, but it sounds different than the stock GAP capsule; it has a smoother top-end response and warmer lows. It excels for female vocals.
The FC 3 circuit is a 2-stage transistor circuit with an "emitter follower" and a low-ratio output transformer. We don't care much for the design; the 2nd stage transistor seems to clip under moderate SPL, and the transformer is not adding any sonic value.
We've developed a version of the KM84 circuit, which is a linear single-stage JFET design with a very high-quality output transformer. We designed custom circuit boards for this circuit, to make room for the best-quality parts we could find. Customers say the results more than justify the cost.
상품명 | [GOLDENAGE] FC3 (골든에이지/방송용/녹음용/마이크) |
---|---|
판매가 | 284,000원 |
국내·해외배송 | 국내배송 |
배송방법 | 택배 |
배송비 | 무료 |
공지사항 | 이벤트 | FAQ | 상품후기 |
상품문의 | 자유게시판 | 갤러리 | 자료실 |
CUSTOMER SERVICE
고객센터
평일 오전 09:00 ~ 오후 06:00
점심 오후 12:00 ~ 오후 01:00 휴무 토/일/공휴일 휴무 |
ACCOUNT
입금계좌
국민은행
509001-01-599-449
예금주 김제수(제이투음향) |